How to mount this spherical bookshelf?

September 28th, 2014, 7:38 am

Posts: 10
Joined: July 1st, 2014, 5:45 am
Hey guys,

How would you go about mounting this to a wall? - whilst keeping mounting panels discreet

Posts: 12
Joined: May 9th, 2014, 1:17 pm
Location: Gothenburg, Sweden
Steel bracket that then attaches to the bookshelf with some kind of hook hidden inside two of the vertical parts?
User avatar
Scott Bennett
full self-realization
full self-realization
Posts: 826
Joined: March 3rd, 2005, 5:39 pm
Location: Denver
Keyhole fasteners?
step two
step two
Posts: 99
Joined: December 9th, 2008, 11:34 am
Location: Boston, MA
How big is the shelf? Without anything showing scale its hard to say what would work.
User avatar
step four
step four
Posts: 343
Joined: April 25th, 2008, 7:05 am
Coroflot: 290422
Location: South Australia
1) Draw pencil lines with a straight edge where your verticals are going to sit.

2) Mark the points where the intersections between the verticals and horizontals will be located.

3) Drill and insert wall plugs into the wall at the points where the intersections are.

4) Drill and countersink holes through the verticals at the same point. and attach them to the wall using a counter sunk screw and long driver extension or very long screwdriver.

5) Push the horizontals onto the verticals. If your tolerance is right, you shouldn't need any adhesive, but if you do, be careful what you use because of runoff. Also if your glue is too strong, you'll need to break the unit to remove it.

Also, come to think of it, you may want to drill your holes first, have someone assist you, and mark the wall with a pen/pencil through the holes to make it more accurate.
step two
step two
Posts: 88
Joined: January 5th, 2005, 11:37 am ... -9_pub.pdf

Although I when I bought a set at Uni (a fair few years ago) I'm sure there was a bracket you fixed to the wall with two protruding lengths of tube that aligned with blind holes in the shelf itself.

Edit. aka like this: ... -7_pub.pdf
User avatar
Dan Lewis
step four
step four
Posts: 353
Joined: December 6th, 2005, 5:47 pm
step two
step two
Posts: 80
Joined: July 3rd, 2012, 6:40 pm
Like others said, Keyhole fittings to go into the back of the shelving unit.

But also, the wall anchor is going to be important as well. I would use a heavy duty wall 'Toggler" or a self drilling wall anchor. They can hold a lot of weight and wont blow out of the wall.
bb-24014_1-4x2-1-2_.jpg (14.64 KiB) Viewed 7181 times
wall-anchors-3.jpg (21.63 KiB) Viewed 7181 times