Tooling Split

Hi People !

I am trying to perform mold split using Sw 2006 into a 2-plate single cavity mold w/o side cores.

Done my parting line – no shut off – done my parting surface

When I tried to do a mold split, this Error message says - Cannot knit sheets together pops out.

Was I doing something wrong in selecting parting lines or parting surface?

Anyone can help please?

here’s the link … http://www.yinshan.com.sg/query1.htm



Thanks!

can you post your part or a picture to describe… if the surfaces will not solidify then it may be a knit problem.