Close

Plastic "Floating" effect

Postby tommyle » June 11th, 2018, 11:32 am


tommyle
step two
step two
 
Posts: 83
Joined: April 12th, 2017, 10:50 am
Location: Florida
How do you guys recommend a plastic part be molded to achieve this floating effect like the Leeo night light attached?
(The part with the logo, it looks like a gap behind it on the front face)
If that is 2 parts, is there a way to get it as 1 part?
Attachments
plastic part question1.jpg
plastic part question1.jpg (10.41 KiB) Viewed 692 times

Re: Plastic "Floating" effect

Postby Cyberdemon » June 11th, 2018, 12:48 pm

User avatar

Cyberdemon
full self-realization
full self-realization
 
Posts: 3393
Joined: February 7th, 2006, 11:51 pm
Location: New York
You can mold a recess, deep enough to "look" similar, but in that particular instance there is just an outer ring, an inner ring. This teardown shows how the flat cap just snaps in place.

Image

If you wanted to mold it as a single part, you would need to have ribs between the two reducing the floating effect (ex every 90 degrees) to hold the two together and you might run into trouble with how the part is gated (as well as potential stresses where the two get held together, as it wouldn't be terribly sturdy.

Re: Plastic "Floating" effect

Postby bepster » June 11th, 2018, 12:55 pm

User avatar

bepster
full self-realization
full self-realization
 
Posts: 1086
Joined: January 11th, 2006, 6:55 pm
Location: Lausanne, Switzerland
Oh hello old friend :D
I designed that Leeo thing during my time at Ammunition.

Yes, Cyberdemon is correct, it's different parts and I would agree on the molding advice.
So to the question by the OP, I don't have much to add :wink:

Re: Plastic "Floating" effect

Postby tommyle » June 11th, 2018, 2:44 pm


tommyle
step two
step two
 
Posts: 83
Joined: April 12th, 2017, 10:50 am
Location: Florida
Cyberdemon wrote:You can mold a recess, deep enough to "look" similar, but in that particular instance there is just an outer ring, an inner ring. This teardown shows how the flat cap just snaps in place.

Image

If you wanted to mold it as a single part, you would need to have ribs between the two reducing the floating effect (ex every 90 degrees) to hold the two together and you might run into trouble with how the part is gated (as well as potential stresses where the two get held together, as it wouldn't be terribly sturdy.


I see what you mean, will have to test to see if the ribs are worth doing then

Re: Plastic "Floating" effect

Postby tommyle » June 11th, 2018, 2:47 pm


tommyle
step two
step two
 
Posts: 83
Joined: April 12th, 2017, 10:50 am
Location: Florida
bepster wrote:Oh hello old friend :D
I designed that Leeo thing during my time at Ammunition.

Yes, Cyberdemon is correct, it's different parts and I would agree on the molding advice.
So to the question by the OP, I don't have much to add :wink:


Nice design Bepster! SKILLZZ


Return to materials and processes