Here are some side and back views I’ve been working on. In the side view, I decided to flatten out the form so that it could rest on a table top much better. In the back view sketch I made some small adjustments to the layout and labeling, then changed the design of the magnetic connector so it will be two parts that were offset inside the rubber base to allow for a continuous rubber base on the bottom.
Just for fun, I did a quick photoshop cut and rotate of the front and back to see how they would look like in stereo mode.
At this point, I think I’m ready to take these sketches and start modeling this concept in foam to evaluate the form and UI. Since this is the Sketching board I won’t post these models here but you can look for them in the Projects section of the forum in the future!
Next, I’m going to work on sketching a Virtual Reality glove that gives grip feedback I’ve been thinking about lately!