Awesome, thanks for the help. I’ll try not to abuse it!
I watched it again today, and I think it’s a binder or flow issue. I’m running suspect binder (sake actually), and it’s not flowing well. Either sake is not a suitable binder, or there’s still a flow restriction somewhere. It was all gunked up with fungus, I swapped the lines and cleaned the filter, but may still have some blockage on a fitting.
The attached image shows the monitor output at the point where it stops printing- I’m guessing the #0 line shows the printhead temp limits, and the current temp is out of range.
Not sure why it’s spreading a new layer while trying to cool the printhead…
Anyway, waiting for a new container of real binder to arrive so I can test it again properly.