Close

studiomkllc
step three
step three
 
Posts: 183
Joined: December 27th, 2012, 11:35 am
Hello, i'm evaluating these two products and was curious if anyone has experience with either and their thoughts? Try to do quicker iterative forms and more surfacing control.


cadjunkie
step three
step three
 
Posts: 137
Joined: May 23rd, 2008, 1:16 pm
Go with Power surfacing. SW ID may not be around later....also Power Surfacing is a Gold Partner which means you work with the tools inside of SW not separately. The $$ is a bit on the high side when compared to the level of cost of SW alone. DDS should either subsidies the plug in or buy them and put it in native.


studiomkllc
step three
step three
 
Posts: 183
Joined: December 27th, 2012, 11:35 am
Ok thanks so much! Been leaning towards power surfacing


Return to software and technology