Short run sand casting or similar

Hi,

I’m looking for short run sand casting places that do smaller decorative parts. Thus far most places only do automotive parts and arent interested. The part is a .25" thick disk with a slight bend in it, to be made from aluminum. Like a small dish with one edge bent upwards. Im open to other processes aside from sand casting. I’m also looking into sheet metal but not sure its a good fit.

thanks!

We’ve used these guys before for a few sand cast prototypes, so I’m guessing a short run would be good for them.

Thanks will check out!

Have you got a sketch or something of what you’re trying to make?

Sheet metal would likely be far more cost and time effective if it is suitable. How many are you making?