Ok! So I think flow issue was taken care of. You were right Sprockets, the ribs were way too tall to fill, so I just cut them to hold the bosses in place. I don’t think extra support for the casing was needed anyway. I’m hoping the corner views show them off a bit better too.
I’ve also added a new project: Michael Coyle - Gearbox
I had been putting it off for a while since it’s pretty numbers-heavy, and the report was 62 pages, so condensing it down was a bit daunting.
I figured I might as well put the numbers up. I don’t expect anyone to read them, but I think the headings are important to indicate that I understand different types of failure criteria, stress concentrations, bearing life, etc.
PS. Thanks simpak, I’m honoured that you registered just for that 